go to main page           go to bowl index page



G24 --- $95.00 --- this is the orientation view --- more pics down below

diameter: 6 1/2"
height: 6"

finish: 11 thin coats of satin-finish spar polyurethane (with UV blocker)

WOODS USED: [SEE DISCUSSION ON THE MAIN PAGE OF THIS SITE IF ANY OF THIS IS UNCLEAR]

base: the very bottom is white oak and the top is mahogany. The middle varies by view, as follows: view 1 aromatic red cedar, oxhorn, paela, makore views 3 and 7: white oak, poplar view 5: basswood, ? (small dark wedge), paela, makore

center: [ONLY APPLICABLE FOR GOBLETS]

view 1: poplar diagonal in a lamination of badi over holly veneer over African blackwood over yellowheart. The blackwood and yellowheart are backed by aromatic red cedar veneer then birch(?). Then all of the preceeding is backed by chechem, aromatic red cedar, maple veneer. Then wedges on each side of the outer lamination are both American black ash.

view 3: bocote, chechem, mahogany

view 5: bubinga over macawood both backed by makore and all of it over Honduras rosewood. The wedges at the sides of the bubinga/macawood are both santos mahogany. The whole section is backed by maple veneer.

view 7: vertical lamination backed by fir then Honduras rosewood. The lamination is, from the top down, redheart, wenge, holly veneer, wenge, curly maple, purpleheart, yellowheart, wenge, thick birch veneer, thick mahogany veneer, thick birch veneer, wenge

flaws/issues: the bottom of the poplar diagonal in view 1 has crushed end-grain, which feels slightly rough to the touch. There is a very small chipout in the santos mahogany on the right of view 5

comments: The bocote in view 3 is a real standout





views 1c and 3c


views 5c and 7c
views 1b and 1d





views 1b, 3b, 5b, and 7b first as the bowl blank and then as the finished bowl